Longacre 78310 AccuLevel (version 2) - Manual

AccuLevel ™
(ver. 2)
Monroe, Wa. 360 453 2030 www.longacreracing.com
5/06 Ver 2
Turn on: Push ON/OFF AccuLevel™ (ver.2) does NOT shut off automatically. Shut off when
you are done. Battery should last a year or more in normal use. See back side for battery door.
Replace w. #2032 ‘coin’ battery (see IMPORTANT NOTE. Recalibrate when you change battery.
Zero: AccuLevel™ maintains its zero when shut off. The ZERO button is ONLY used to
compare one angle to another. Place AccuLevel™ on a surface and push ZERO. The display
will go to 00.0 00.0 00.0 00.0 00.0 and ABS ABS ABS ABS ABS will disappear. Move to a different surface to compare the difference. Push
ZERO to return to normal absolute readings.
FOR NORMAL USE
ABS ABS ABS ABS ABS MUST BE ON DISPLAY.
To hold reading: Push “HOLD” The display will show HOLD and flash (see example). When
HOLD stops flashing (approx. 6 sec.) the reading is held on the display. Push “HOLD” again to go
back to active reading.
To CALIBRATE: Place AccuLevel™ on a reasonably level table top (does not need to be
perfectly level). Push ON/OFF and hold for 6 seconds. Unit shuts off. Push ON/OFF again and - 1 - - 1 - - 1 - - 1 - - 1 -
appears on the display. Push ZERO. - 1 - - 1 - - 1 - - 1 - - 1 - will begin to flash and in a few seconds - 2 - - 2 - - 2 - - 2 - - 2 - will appear.
Turn unit around 180 O in the same spot and push ZERO again. - 2 - - 2 - - 2 - - 2 - - 2 - will begin to flash and in a few
seconds normal readings will reappear. Calibration is now complete.
Digital Level Measurement from 0.0 O to 90.0 O
Pointers on display -
-
show direction of tilt.
(If AccuLevel ™ is used for measuring
very small angles this feature will tell
you which way the tilt is.)
LEVEL
Note direction of pointers
4.3 4.3 4.3 4.3 4.3
4.3 4.3 4.3 4.3 4.3
1.8 1.8 1.8 1.8 1.8
ON/OFF HOLD ZERO
ABS ABS ABS ABS ABS
HOLD HOLD HOLD HOLD HOLD
AccuLevel ™
Should be on
display for
normal use. Push
ZERO if it is
not. (ABS
ABS ABS ABS ABS stands
for absolute or
true
O )
HOLD HOLD HOLD HOLD HOLD will ONLY
be on if the unit
is holding a
reading.
Do not drop the unit. Keep it clean and dry and avoid strong
electrical or magnetic fields. Do not push 2 buttons at once.
If you accidentally hold the ON/OFF button for 6 seconds -1- -1- -1- -1- -1- will
appear and you will need to recalibrate before further use. See above.
This only takes a minute or less.