High Lifter Lift Kit for Yamaha Rhino 450_660 (2004 to mid-2006) - Manual (Page 7)

11) Next attach the top of the shock to the rear lift brackets using another 12 x 80 hex bolt and 12mm lock
nut. (Use 1 left and 1 right bracket)
12) Make sure that the brackets run 20 degrees to the shock mount.
13) Tighten all bolts to 45ft lbs of torque. Make sure that they are tight enough so that the brackets do not
rotate out of place.
14) Repeat steps for opposite side.
15) Install the wheels, torque wheel lug nuts to manufacturer’s specifications, lower and remove jack.
Check for clearance problems or misalignment.