High Lifter Lift Kit for Yamaha Rhino 450_660 (2004 to mid-2006) - Manual (Page 5)

Rear Lift
1) Place jack under ATV at the rear of the bottom skid plate and lift until the weight is off of the
suspension. Be careful to secure the ATV properly so as not to fall off the jack.
2) Remove the rear wheels.
3) Remove the knuckle assembly.
4) Remove the shock from the ATV and secure the rear CV axle out of the way.
5) You will need to use a grinder to remove portions of the lower shock mount. There is a washer
welded on the outside of the lower shock mount (Rear Side) that will need to be completely removed.
This can be done using a grinder. You are grinding to clearance the axle.
NOTE: GRIND SIDE NEAREST AXLE!!!!!
Grind this area
Grind this washer near axle