GE Healthcare Avance - Manual (Page 6)

6
Electrical Specifications
Current leakage
100/120 V: < 300μA
Power
Power input: 100-120 Vac, 50/60 Hz
Power cord: Length: 5 m/16.4 ft
Rating: 10A @ 220 Vac or
15A @ 120 Vac
Inlet/outlet modules (100V)
System circuit breakers: 15A
Outlets (optional): 3 outlets on back, 2-2A,
1-4A individual breakers,
isolation transformer standard
Pneumatic Specifications
Auxiliary common gas outlet (optional)
Connector: ISO 22 mm OD and 15 mm ID
Gas supply
Pipeline input range: 280 kPa to 600 kPa/
41 psig to 88 psig
Pipeline connections: DISS-male, DISS-female,
DIN 13252, AS4059, BSPP 3/8,
S90-116, or NIST
All fittings available for O
2
,
N
2
O, and Air, and contain
pipeline filter and check valve.
Cylinder input: Pin indexed in accordance with
CGA-V-1 or DIN (nut and gland);
contains input filter and check valve.
Note: Maximum 2 cylinders
Primary regulator
diaphragm minimum
burst pressure:
2758 kPa/400 psig
Primary regulator
nominal output:
≤ 345 kPa/50 psig
Pin indexed cylinder and
DIN cylinder connections
O
2
controls
Method: N
2
O shut off with loss of
O
2
pressure
Supply failure alarm: Range: 193 kPa to 221 kPa/
28 psig to 32 psig
Sounds at maximum volume
every 10 seconds
O
2
flush: Range: > 35 L/min
Alternate O
2
(safety flow)
Range: 500 mL/min minimum to 10 L/min
Indicator: Flow tube
Indicator accuracy: ±5% full scale
Fresh gas
Flow range: 0 and 150 mL/min to 15 L/min
(minimal flow capable)
Total flow accuracy: ±10% or ±40 mL/min of setting
(larger of)
O
2
flow accuracy: ±5% or ±20 mL/min of setting
(larger of)
Balance gas
flow accuracy:
±5% or ±20 mL/min of setting
(larger of) Air/N
2
O
O
2
concentration range: 25% to 100%
O
2
concentration
accuracy: ±8% V/V for flows < 400 mL/min
±5% V/V for flows > 400 mL/min
to 1 L/min
±2.5% setting for flows > 1 L/min
Electronic mixer
response time:
500mS (10% to 90% flow step)
Compensation: Temperature and atmospheric
pressure compensated to
standard conditions of 20°C
and 101.3 kPa
Hypoxic guard: Electronic
Materials
All materials in contact with patient breathing gases are free
of natural rubber latex.
Environmental Specifications
System operation
Temperature: 10° to 40°C/50° to 104°F
Humidity: 15 to 95% relative humidity
(non-condensing) per IEC 68-2-3
Altitude: -440 to 3565 m/
500 to 800 mmHg
M1042385-2.qxd:M1042385-1 19.11.2008 10:48 Sivu6