Assembly instructions, 5" trp stem casters with bumpers, Polyurethane stem casters with bumpers – Focus Foodservice Shelving Solid STAINLESS STEEL - Assembly Instructions User Manual

Page 6: Polyurethane threaded casters with bumpers, S hooks/shelf connectors, 18" chromate side handle, 24" chromate side handle

Call Customer Service at 1.800.968.3918 | Fax 1.800.968.4129

www.focusfoodservice.com

FOODSERVICE, LLC

ASSEMBLY INSTRUCTIONS

Model# FTPRCST5

5" TRP Stem Casters with Bumpers

Model# FSCAST5 5"

Polyurethane Stem Casters with Bumpers

Model# FTCAST5 5"

Polyurethane Threaded Casters with Bumpers

Step 1

Slide a plastic bumper up the bottom of post about 4˝ - 6˝, smooth side facing up.

Step 2

For stem - Install caster by inserting it into the hole in the bottom of the post.

For screw-in - Remove leveling assembly by turning it counter-clockwise.

Install caster by screwing it into the hole at the bottom of the post.

Step 3

Slide the plastic bumper down to the bottom of the post.

Step 4

Repeat these steps to install the remaining 3 casters.

Step 5

Then assemble shelving unit.

Note:

The casters can be locked in place by turning the steel lock mechanism

counter clockwise on the side of two of the casters.

Weight capacity - Stem - 300 lbs. per caster

Screw-In - 200 lbs. per caster

S Hooks/Shelf Connectors

Model# 93333

Chromate

Model# 93333GN

Green Epoxy Coated

5" Industrial Stem

Casters with Bumpers

5" Industrial

Screw-In Casters

with Bumpers

Model# FXHAND18C

18" Chromate Side Handle

Model# FXHAND24C

24" Chromate Side Handle

Helpful Hint:

When placing the plastic tapered sleeves onto the posts, slide the plastic

tapered sleeves up or down on the post until you feel it “snap” into the lines or grooves of the post.
It is normal to have a slight gap in-between the two pieces of the plastic tapered sleeves when it is
placed on the post.

Installing the Side Handle

Install handle on the two posts that are 18˝ apart and choose the desired height for the side

handle (Note: Handles can be adjusted every 1˝). Snap 2 plastic tapered sleeves into place

on each post at the desired height. With the wider portions of the round collars facing the

bottom of the unit, slide the side handle down from the top of the posts onto the plastic

tapered sleeves. (Note: Make sure to leave enough room to install shelf above handle. )

Two per shelf required.

rev. 1212