beautypg.com

Focus Foodservice FPS-Plus Polymer Shelving with SaniGard Anti-Microbial Protection - Assembly Instructions User Manual

Assembly instructions, Fps-plus polymer shelving with sanigard, Anti-microbial protection

background image

continued on backside

ASSEMBLY

INSTRUCTIONS

FPS-Plus Polymer Shelving with SaniGard

Anti-Microbial Protection

DIAgRAM 1

DIAgRAM 2

Top

Top

FOODSERVICE, LLC

Note:

Please dispose of loose, round plastic pieces. These are used to

separate the shelves for shipping purposes.

Helpful Hint:

When placing the plastic tapered sleeves onto the posts

(Step 1), slide the plastic tapered sleeves up or down on the post until you
feel it “snap” into the lines or grooves of the post. It is normal to have a
slight gap in-between the two pieces of the plastic tapered sleeves when
it is placed on the post.

Step 1

Choose the desired height of the bottom shelf (for added

stability, it is recommended that the bottom shelf is installed

no more than 6˝(2 – 3 lines) from the floor and the top

shelf no more than 6˝(2 – 3 lines) from the top.) Snap two

(2) plastic tapered sleeves, with the arrows facing up, at the

desired height on each post. (See Diagram #1) Shelves can

be adjusted every 1˝. (Note: Double grooves in the posts are

placed every 8th groove for simple shelf height reference.)

Step 2

Place shelf on its side, making sure the wider portion of the

four (4) round shelf collars are facing the bottom of the unit,

slide the top of the posts through the round shelf collars on

each corner of the shelves. Push the shelves firmly onto the

plastic tapered sleeves. (See Diagram #2)

Step 3

After installing the bottom shelf, set the unit upright

Step 4

Snap the plastic tapered sleeves into place on posts at the

next desired shelf height. Slide the shelf down from the top

of the posts onto the plastic tapered sleeves and repeat this

step for the remaining shelves. (Note: A rubber mallet may be

used to tap each corner of the shelves so they firmly install

onto the plastic tapered sleeves.) (Note: The leg levelers may

need to be utilized in order to make the unit level or flush

against the wall.)

WARNINg:

HEAVY OBJECTS MUST BE PLACED--NOT

DROPPED--ONTO THE SHELVES!!