EVS XT2 Version 11.02 - July 2013 Configuration Manual - Manual (Page 216)

• Cam C and Cam D can be mapped to network cameras using respectively the Cam C
and Cam D parameters.
Cam Mapping
Description Enables or disables the cam mapping feature.
Values Yes / No
Default Values No
Cam X
Availability This setting is displayed for each available camera line that can
be mapped to a network camera.
Description Specifies the network camera mapped to the corresponding
local camera.
Values The available network camera that can be mapped.
Default Values none
3.9.13. Hypermotion Management
Principles
The hypermotion cameras can be controlled by the LSM Remote Panel. The camera is
linked via a RS422 or LAN PC connector to the same XT2+ server as the controlling
Remote Panel.
In setups including a hypermotion camera, the following principles apply:
• An XT2+ server cannot control more than one hypermotion camera.
• The hypermotion camera is used with the classical channel configurations.
• Not all Multicam LSM configurations with several PGMs and several Remotes are
supported within the current RS422 and channel configuration constraints.
• If the Remote Mode setting in the Hypermotion Controller settings is set to
‘Hypermotion only’, an additional menu is made available in the main menu of the LSM
Remote Panel.
208 3. Multicam Configuration
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013