EVS XT2 Version 11.02 - July 2013 Configuration Manual - Manual (Page 116)

Supported Modes
1 PGM Mode
In a single PGM mode, users working in a Spotbox configuration with IPDirector no longer
need to use two channels in PGM/PRV mode to play back a playlist with effects.
When they activate the mix on one channel feature, they can play back a playlist with
effects using only 1 PGM.
Multi PGM Mode
In a multi PGM mode, the Load PL setting interacts with the use of the Mix on one
channel setting as shown in the table below. The table summarizes how the play
channels are used when you load a playlist in 2 PGM mode, depending on the defined
settings:
Mode
Mix on one
channel?
Load Playlist?
V3X Mod 1 V3X Mod 2
OUT1
Prim.
link
OUT1
Sec.
link
OUT2
Prim.
link
OUT2
Sec.
link
2 PGM No Conditional Cut Cut
2 PGM Yes Conditional Mix Mix
2 PGM No Always Mix PRV
2 PGM Yes Always Mix PRV
When users set the Load PL parameter to 'Conditional', and enable the Mix on one
channel setting, they can use load playlists on both play channels, and play them with
effects, or only play back a playlist with effects on PGM1, while using PGM2 to play back
something else.
Mix on One Channel Settings
User Interface
These fields are available in the following interfaces:
• in the Multicam Configuration window, Channels tab, in the advanced display mode:
◦ on page 5, 6 or 7 on the server-based application
◦ on page 1 on the web-based interface
• in the Technical menu of the Remote Control Panel (T2.9)
Warning
The Mix on one channel settings are only available if the license code 31 is
valid.
108 3. Multicam Configuration
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013