EVS IPDirector Version 6.2 - June 2013 RECORDER PANEL User Manual - Manual (Page 20)

4. Creating a Clip
4.1. Introduction
As soon as a recorder channel has been selected, users can create a new clip from the
record train thanks to the clip creation functions of the Clip Creation pane.
4.2. Clip Settings
Several settings related to clip creation can be defined under Tools > Settings. They
relate to the display of the Save Clip window, automatic ways to name clips would the
Save Clip window be displayed or not, the guardbands duration or the default clip duration.
Specific settings also exist for the creation of clips on ganged recorders, the creation of
sub-clips from linked clips, or the trimming of linked clips.
See the General Functions user manual .
4.3. How to Create a Clip
To create a clip from the Recorder Panel module, proceed as follows:
1. Click the Mark IN button
The IN point is set.
2. Click the Mark OUT button
The OUT point is set and the clip duration is displayed in the Duration field.
3. Click the Save button.
◦ If the Show Save Clip Window setting has not beenselected in the Tools >
Settings > Clips > General category, the clip is saved according to the settings
defined in the Tools > Settings > Autoname category.
The procedure is finished.
◦ If the Open Save Clip Window setting has been selected, the Save Clip window
will open. See
the Control Panel user manual .
Follow steps 4 and 5.
4. Fill in a clip name and any desired information in the Save Clip window.
5. Click the Save button.
The clip is saved in the IPDirector database.
12 4. Creating a Clip
EVS Broadcast Equipment S.A. - June 2013 Issue 6.2.A