Managing channels, Assigning a recorder channel – EVS IPDirector Version 6.2 - June 2013 RECORDER PANEL User Manual User Manual

Page 15

Managing Channels

3.1.

Recorder Panel Use Depending on
EVS Video Server Mode

LSM Mode

If an EVS video server is in LSM base mode, the Recorder Panel is for information only.
Each recorder channel starts recording from server start up and continues in a loop record
mode. The recorder channel cannot be started or stopped from an IPDirector workstation
and the Recorder Panel will show the current recording timecode and its record status.

IPDP Spotbox mode

If the EVS video server IPDP Spotbox mode is used, the Recorder Panel buttons can be
used and recorder channels can be started or stopped using this panel.

3.2.

Assigning a Recorder Channel

Introduction

To be able to perform actions on a recorder channel from a Recorder Panel, the recorder
channel must be assigned to the Recorder Panel.

There are several ways to assign a recorder channel to a Recorder Panel .

IPDirector - Version 6.00 - User Manual - Recorder Panel

3. Managing Channels