AASTRA 600c_d for OpenCom 1000 User Guide EN - Manual (Page 93)

87
Pre alarm Use Change to switch the pre-alarm for all alarm types on or off.
Alarm tone The pre-alarm can be sounded with or without an alarm tone on
the handset. If the alarm tone is activated, the signalling volume
increases progressively.
Vibrator You can set whether the pre-alarm should also be signalled with
vibrator call.
Duration You can set the time (10s … 75s) that should elapse before the
emergency number is dialled. An increasingly loud ring tone (alarm
tone) is signalled on the handset during this time (provided it is
activated). The alarm can still be cancelled during the pre-alarm.
During the pre-alarm the alarm can still be cancelled with the follo-
wing measures:
•
With mandown alarm: By pressing Esc or holding the handset
vertical for at least 4 seconds.
• With the escape alarm: By pressing Esc.
• With the no movement alarm: By pressing Esc or shaking the
device sideways for 1 – 2 seconds.
Mandown Use Change to switch the mandown-alarm on or off.
Alarm in conversation
Switch off this feature to prevent alarm activation by mistake
during an active call.
Delay Allows you to set the amount of time the handset can remain out-
side the vertical position before a pre-alarm is triggered (1s …
75s).
Please switch Vibra call off in the Ringer settings (see page 72) if
you wish to use the mandown alarm.
Angle Select the inclination angle of the handset in which the alarm will
be triggered.
Steep: Approximately 45° from the vertical position.
Medium: Approximately 55° from the vertical position.
Flat: Approximately 65° from the vertical position.
The inclination angle will be detected in each axis of the handset.
No movement alarm
Use Change to switch the no movement alarm on or off.
Alarm in conversation
Switch off this feature to prevent alarm activation by mistake
during an active call.
Delay Allows you to set the amount of time the handset can remain still
before a pre-alarm is triggered (1 s … 75 s). To prevent unwanted
Devices menu