Blue Ox BX88193 - Manual (Page 19)

Installation - Wireless Remote Indicator
(con’t.)
6. Find the cold side of the brake signal wire
- under the dash and above the brake pedal.
It is usually located behind what looks like
a push button switch that releases when
the brake pedal is pressed – activating the
brake lights. Slip the slotted end of the
ScotchLock connector around the cold side
of the brake signal wire under the dash.
Insert the transmitter wire into the partially
plugged side of the ScotchLock connector.
7. Bring the transmitter wire out from under
the dash to a fixed location (i.e. the glove
compartment or the side panel). Cut the
transmitter wire, crimp the female terminal
bullet onto the brake signal wire, and
crimp the male terminal bullet onto the
transmitter wire.
8. Plug the transmitter’s power cord into the
towed vehicle’s 12-volt accessory receptacle.
Then, connect the two terminal bullets
together.
9. Attach Velcro to the back of the transmitter
and affix to a convenient location in the
towed vehicle. Mount with the front side of
the transmitter (labels are on the back side)
facing the rear of the towing vehicle.
Steps 6 & 7
Date 09/06 292-2658 16 of 18
ScotchLock
Brake Signal Wire
Male Terminal Bullet
Female Terminal Bullet
Transmitter Wire
Transmitter