Blue Ox BX88193 - Manual (Page 10)

Installation
This section will explain how to install the Apollo®.
Step 3
Step 2


Note: Before installation, verify that a 12-
volt accessory receptacle is available and in
working order. Test with a cell phone charger
or other device. Be sure that the towed
vehicle’s ignition is in the “tow” position (key
turned forward, but engine NOT running)
when testing.
1. Park the towed vehicle on a level surface.
2. Remove the protective cap from the
actuator arm.
3. Thread the hex jam nut onto the actuator
arm.
4. Thread the fitting adapter of the brake
bracket onto the actuator arm and tighten.
5. With the towed vehicle’s engine off, press
the brake pedal four to five times with your
foot. Doing this removes vacuum in the
braking system.
6. Adjust the driver’s seat to the rear-most
position to allow for more working space.
Place the Apollo on the floorboard between
the seat and the brake pedal. Have the
actuator arm (extended) facing the brake
pedal.
Step 4
7 of 18 292-2658 Date 09/06