American Magnetics 05500PS-430-601 High Stability Integrated Power Supply System - Manual (Page 38)

20 Rev. 5
Installation
Bipolar High-Stability Supply
h. Connect two jumpers (17) from terminal block position S- to M- and
from S+ to M+ on the Master 1 power supply unit.
i. Connect the special DB15 analog I/O cable from the PROGRAM
Connect the CT power supply to the TRANSDUCER POWER
connector (5) on the rear of the Model 430 Programmer.
j. Connect the current transducer output to the current transducer
SIGNAL connector (4) on the rear of the Model 430 Programmer.
k. Connect the special DB15 analog I/O cable from the PROGRAM
OUT connector (14) on the back of the Model 430 Programmer to
the DB15 ANALOG I/O connectors on the rear of the Master (7) and
each Slave (20) power supply unit.
l. Install an instrumentation cable between the magnet support
stand top plate connector (8) and one of the MAGNET STATION
connectors (11) on the rear of the Model 430 Programmer.
m. Optional: Install an instrumentation cable between one of the LHe /
TEMP connectors (10) on the rear of the Model 430 Programmer
and the Model 13x Liquid Helium Level Instrument and/or
temperature instrument (9). Refer to section A.2 on page 154.
n. Optional: Install an instrumentation cable between the QUENCH
I/O connector (13) on the rear of the Model 430 Programmer and
Aux connector J2 on the rear panel of the Model 13x Liquid Helium
Level Instrument (12). Refer to section A.6.2 on page 159.
o. Connect each device line cord and Model 601 power adapter from
the respective device to the appropriate power receptacle.
p. Remote communications via Ethernet and/or RS-232 can be
accomplished by connecting suitable cabling to the Model 430
Programmer rear panel ETHERNET and/or RS-232 connectors.
2.6 Special Configurations
The Model 430 Programmer has been designed for optimal operation with
a superconducting magnet (i.e. a very low resistance, high inductance
load) with a persistent switch. The Model 430 Programmer is capable of
controlling current to other loads; however, some modification to the
Model 430 Programmer settings and/or connections must usually be made.
Two commonly encountered configurations are: 1) superconducting
1. Do not add terminal block jumpers to the slave units. Only the single or master unit
is jumpered.