SUUNTO Cobra - Manual (Page 22)

20
m
NO DEC TIME
T
C
B
MAX
DIVE TIME
MAX
bar
AIR TIME
3.3. DIVING IN AIR MODE
3.3.1. BASIC DIVE DATA
The dive computer will remain in the Surface mode at
depths less than 1.2 m [4 feet]. At depths greater than
1.2 m the instrument will go into the Diving mode
(Fig. 3.7.).
All information on the display is labeled (Fig. 3.7.
and 3.8.). During a no-decompression stop dive, the
following information will be displayed:
• your present depth in meters [ft]
• the Remaining Air time
• the Altitude Adjustment setting on the left
side of the center window with a wave and
mountain symbols (A0, A1, or A2) (see Table
3.3.)
• the Personal Adjustment setting on the left
side of the center window with a diver symbol
and + signs (P0, P1, or P2) (see Table 3.4.)
• the maximum depth during this dive in meters
[ft], indicated as MAX
• the cylinder pressure in bar [or psi] displayed
in the lower left corner
• the elapsed dive time in minutes, shown as
DIVE TIME in the lower right corner
• the available no-decompression time in
minutes in the center window as NO DEC
TIME and as a bar graph on the left side of
the display. It is calculated based on the fi ve
factors described in Section 6.1. “Operating
Principles”.
Fig. 3.9. Diving display. Present cylinder pressure is 210 bar [3045 psi]
and remaining air time 41 minutes. Alternative display of current time
and temperature is shown for 5 seconds after pressing TIME button.
Fig. 3.7. Dive has just begun
and no air time is shown. First
estimate of remaining air time
will be shown after 30-60
seconds.
Fig. 3.8. Diving display. Present
depth is 19.3 m [63 ft] and no-
decompression stop time limit
is 23 minutes in A0/P1 mode.
Maximum depth during this
dive was 19.8 m [65 ft], elapsed
dive time is 16 minutes.
TIME DIVE
m
NO DEC TIME
T
C
B
MAX
bar
m
NO DEC TIME
T
C
B
MAX
DIVE TIME
MAX
bar
AIR TIME
TIME ° C