Garmin GPS 60 - Manual (Page 53)

43
GPS Navigation
To change the Serial Data Format:
1. From the Setup Menu, highlight ‘Interface’ and press ENTER .
2. Highlight the ‘Serial Format’ field and press ENTER .
3. If you select Text Out and/or RTCM In, additional fields will appear.
Use the ROCKER key to highlight ‘Baud Rate’ and press ENTER . Use
the ROCKER key to highlight the desired setting and press ENTER .
4. For Garmin DGPS or RTCM In/NMEA Out, use the ROCKER key to
highlight ‘Beacon’ and press ENTER . Use the ROCKER key to select
‘Scan’ or ‘User’ and press ENTER .
If you select ‘Scan,’ the GPS 60 will automatically direct the beacon
receiver to scan for available beacon transmitters.
If you select ‘User,’ select the ‘Freq’ and ‘Bit Rate’ fields and enter
the appropriate settings. The beacon status, signal-to-noise ratio and
distance to beacon are displayed in the bottom of the page.
The Setup Menu