Garmin GPS 95STD - Manual (Page 89)

A-3
ROM Failed - The GPS 95 has detected a failure in its permanent memory.
If this message occurs, the unit is unusable and should be taken to an
authorized GARMIN service center.
Route is Full - An attempt has been made to add more than 30 waypoints
to a route. The GPS 95 will not allow more than 30 waypoints per route.
Route Not Empty - An attempt has been made to copy a route to a non-
empty route. The GPS 95 will not allow you to copy a route to a non-empty
route.
Route Waypoint - An attempt has been made to delete a waypoint which is
a member of one or more routes. You must remove the waypoint from all
routes before the waypoint can be deleted.
RTCM Input Failed - The GPS 95 was receiving RTCM inputs, but the data
signal has been interrupted.
Searching the Sky - The GPS 95 is in the search-the-sky mode. Allow the
unit to complete its data collection before turning it off. This process takes
approximately 15 minutes.
Start altitude chng - The altitude change entered on the VNAV Page is
about to begin.
Steep Turn Ahead - This message appears approximately one minute prior
to a turn that requires a bank angle in excess of 25 degrees in order to stay
on course.
Stored Data Lost - Stored user data, including waypoints, routes, and
satellite orbital data has been lost due to a low memory battery.
Timer Expired - The count down timer has expired.
Track Memory Full - The track memory is full. Go to the Track Log Setup
Page to clear the memory.
Transfer Completed - Data transfer operations are complete.
VNAV cancelled - The VNAV function has been cancelled due to a change
in the active route.
WPT Exists ____ - You have entered a waypoint name on the AutoStore TM
Page that already exists in memory. Enter a waypoint name that does not
exist.
WPT Memory Full - The waypoint memory is full. You should delete unused
waypoints to make room for new waypoints.