Garmin GPS 95STD - Manual (Page 26)

3-7
To select a waypoint using a limited scan...
· Select a blank waypoint identifier field. (If the identifier field is not blank,
press CLR first.)
· Enter the starting letter, or letters, of the desired waypoint identifier.
You may limit the scan to the level that you desire. For example, if you
enter “C” the GPS 95 will scan through all waypoints that begin with the
letter “C”, but, if you enter “CRY” the GPS 95 will display only those
waypoints that begin with “CRY”.
· Press WPT to begin scanning.
· Press the right arrow key to sequence through the available waypoints.
If you pass the desired waypoint, you may press the left arrow key to
scan backwards through the list.
· Once the desired waypoint is selected, press ENT to accept the
waypoint and complete the scan. The selected waypoint will be
displayed on the waypoint identifier field.
3.5 REVIEWING WAYPOINTS
The GPS 95 allows you to quickly review waypoint information without
entering the waypoint identifier. For example, you may review information
regarding the waypoints in a route, or review the definition of the nearest
waypoints. In general, if the cursor is over a waypoint identifier, you may
quickly review the information about that waypoint.
To review a waypoint definition...
· Place the cursor over a waypoint identifier (using the arrow keys) and
press ENT. The Waypoint Definition Page is displayed showing
information for the selected waypoint.
· With the cursor over “USE?”, press ENT to exit the review process and
return to the previous page.