Garmin GPS 95STD - Manual (Page 29)

4-1
CHAPTER 4
GETTING THERE FAST - GOTO
The GOTO function allows you to quickly set a course from your position to
any waypoint.
To activate the GOTO function...
· Press GOTO. The GOTO Page will be displayed with the cursor on
the GOTO waypoint field. If the GPS 95 is currently navigating to a
waypoint, that waypoint will be offered as the default GOTO waypoint.
If the waypoint field is blank or the waypoint shown is not the desired
destination, type the new name right over the old name. NOTE: If a
non-existent waypoint name is entered, the GPS 95 will assume that
this is a new waypoint and will display a blank Waypoint Definition
Page where you may enter the new waypoint's coordinates.
· Confirm the GOTO waypoint by pressing ENT. The Navigation
Summary Page will be displayed with the D-bar on the CDI centered.
(See Section 5.1 for more information on the Navigation Summary
Page and the CDI.)
You may also select the desired GOTO waypoint identifier by scanning. (See
Section 3.4 for more information on waypoint scanning.) Alternatively, the
GOTO function may be quickly activated from any page (e.g., the Nearest
Waypoint Page or the Waypoint List Page) by placing the cursor over the
desired waypoint name and pressing GOTO. The GOTO Page will be
displayed with the cursor on the GOTO waypoint name. The GOTO function
will be activated when the ENT key is pressed.
You may cancel the GOTO function at any time.