Garmin nuvi 900T User Manual
Page 66
0
nüvi 900 Series Owner’s Manual
Appendix
Problem/Question
Solution/Answer
The touch screen is
not responding to my
touches properly.
Slide the
Power
key to the left and hold it for 8 seconds. Release
the
Power
key, and press your finger to the screen. Hold your finger
on the screen for about 30 seconds until the calibration screen
appears (white screen with “Press dot”).
I cannot get traffic
information.
Verify that you are in a coverage area. You must be in a coverage
area to get the traffic information for that area.
Verify that the FM TMC Traffic receiver is connected to the power
connector on the cradle and also connected to a power outlet
in your vehicle. (The traffic receiver is included in some nüvi
packages.)
My phone will not
connect to the nüvi.
Touch
Tools
>
Settings
>
Bluetooth
. Verify that the Bluetooth field
is set to
Enabled
.
Make sure your phone is turned on and is less than 10 meters
(about 33 feet) away from your nüvi.
See
for more help.
How do I know my nüvi
is in USB mass storage
mode?
When your nüvi is in USB mass storage mode, a picture of a nüvi
connected to a computer is shown. Also, you should see two new
removable disk drives listed in
My Computer
.
My computer never
senses that the nüvi is
connected.
1. Unplug the USB cable from your computer.
2. Turn the nüvi off.
3. Plug the USB cable into a USB port on your computer and into
your nüvi. The nüvi automatically turns on and goes into USB
mass storage mode.
Ensure your nüvi is connected to a USB port and not a USB hub.