Additional information about your seat belts – Acura 2010 MDX User Manual
Page 30
The lap/shoulder belts in the center
seat of the second row and both of
the third row seats are equipped with
a detachable anchor that has two
parts: a small latch plate and a
buckle.
The detachable seat belt should
normally be latched whenever the
seat-backs are in an upright position.
For more information about the
detachable seat belt, see page 154.
Automatic Seat Belt Tensioners
For added protection, the front seat
belts are equipped with automatic
seat belt tensioners. When activated,
the tensioners immediately tighten
the belts to help hold the driver and a
front passenger in position.
The tensioners are designed to
activate in any collision severe
enough to cause the front airbags to
deploy, or if a sensor detects your
vehicle is about to roll over (see page
34).
If a side curtain airbag deploys
during a side impact, the tensioner
on that side of the vehicle will also
deploy.
The tensioners can also be activated
during a collision in which the front
airbags do not deploy. In this case, the
airbags would not be needed, but the
extra tension in the seat belt could be
helpful.
When the tensioners are activated,
the seat belts will remain tight until
they are unbuckled.
DETACHABLE ANCHOR
Additional Information About Your Seat Belts
23
Driver
and
Passenger
Safety