Acumen AiM 108CH - Manual (Page 11)

- 11 -
If the above settings are done, you can click on Connect button to test if the device is properly
For default username and password information, please see appendix for detail.
Chapter 1-3. Device Type
There are few device type drivers for connecting streaming:
 RTSP —Connect an IP camera with RTSP streaming protocol.
 DVR/NVR-JPEG--Connect a DVR/NVR by MJPEG protocol.
 DVR/NVR-H264
—Connect a DVR/NVR by H.264 protocol.
 AIM-JPEG —Connect a AIM by MJPG protocol.
 Low Bitrate IP Camera —Connect an IP camera by low bitrate protocol.
 Low Bitrate DVR Camera--Connect an IP camera by low bitrate protocol.
 Looping Camera
—For demonstration purpose, you can choose Looping Camera at
Device Type selection box for duplicate video channel without physically connecting
to an IP camera or a DVR’s camera. It can reduce bandwidth for the network video.
Chapter 1-4. ONVIF Setting
To use RTSP streaming, please first setup ONVIF protocol. The detail setting of ONVIF is
described as below:
 Profile —A user can select different streaming profile such as H.264 720P or JPEG
720P.
 Protocol —Streaming protocol such as RTP/UDP, RTP/TCP, or RTP/TCP/HTTP.

Quality
—Compression quality

Brightness: Brightness setting of the video
 Saturation —Saturation setting of the video
 Contrast —Contrast setting of the video
 Sharpness —Sharpness setting of the video

Frame rate
—Change frame rate setting of the IP camera.

Bit Rate
—Bit rate setting of the video