AcuRite 75110 Weather Station - Manual (Page 5)

Place the main unit in a dry area free of dirt and dust. To help ensure
an accurate indoor temperature measurement, be sure to place the
main unit out of direct sunlight, and away from any heat sources or
vents in your home.
There are 2 placement options for the main unit. You may hang the
main unit on a wall using the integrated hang hole on the back.
Alternatively, you may place the main unit on a table top or other flat
surface utilizing the removable Main Unit display stand.
Placement of Main Unit
The wireless sensors MUST BE PLACED OUTDOORS to observe
outdoor weather conditions and relay them to the main unit display.
The wireless sensors must be placed less than 100 feet from the
main unit.
Placement of Sensors
- 9 - - 8 -
PLACEMENT
1. Attach the temperature &
humidity sensor to the
mounting bracket by simply
sliding into the bracket.
2. Attach to a solid vertical
surface out of direct sunlight for maximum performance. Attach the
mounting bracket utilizing the included screws and wall anchors (if
applicable). Depending on the mounting surface, other steps may need
to take place to ensure the sensor is mounted successfully.
Alternatively, the wireless temperature sensor may be mounted onto a
PVC pole. See “Alternative Mounting Option” later in this section.
Wireless Temperature
& Humidity Sensor
PLACEMENT
1. Attach the wind sensor to the
mounting bracket by simply
sliding into the bracket.
2. The sensor must be mounted
with the bracket pointing NORTH
as indicated on the bracket and
on the top surface of the wind sensor itself. The wireless wind sensor
should be mounted high above all potential wind obstructions for
maximum performance, keeping in mind it must remain within the 100
ft. wireless range of the main display unit.
Attach to a solid surface utilizing the included screws and wall anchors
(if applicable). Depending on the mounting surface, other steps may
need to take place to ensure the sensor is mounted successfully.
Alternatively, the wireless wind sensor may be mounted onto a
PVC pole. See “Alternative Mounting Option” later in this section.
Wireless Wind Sensor
PLACEMENT
1. The wireless rain collector MUST be placed on a flat, level surface to
allow for proper rain measurement. Make certain the rain collector is
not placed in a low spot that may become flooded or in an are where
there are obstructions above it such as trees or other structures that
may block the rain from being collected properly.
It is strongly recommended that the rain collector be mounted to a solid,
flat surface such as a deck railing for best results. Depending on the
mounting surface, other steps may need to take place to ensure the
sensor is mounted successfully.
Wireless Rain Collector
NORTH NORTH
OK
DO NOT PLACE IN WATER
OR IN UNEVEN OR
LOW SPOTS THAT
MAY BECOME FLOODED.
DO PLACE ON A LEVEL
SURFACE WITH NO
OBSTRUCTIONS
ABOVE.
DO NOT PLACE IN
AREAS WHERE PLANT
GROWTH CAN GROW
INTO CASE .
DO NOT PLACE IN AN
AREA WITH
OBSTRUCTIONS ABOVE