AcuRite 75110 Weather Station - Manual (Page 4)

SECTION 3 • PLACEMENT
Now that setup is complete, you must choose a location to place the 3
wireless sensors and the main unit. The wireless sensors MUST be
placed LESS THAN 100 feet away from the main unit.
This wireless weather station uses radio frequency for communication,
which is susceptible to interference from other electronic devices and
large metallic items or thick walls. Always place both units at least 3 feet
away from appliances ( TV, microwave, radios, etc. ) or objects ( large
metal surfaces, thick stone walls, etc. ) that may interfere with the
wireless communication.
- 7 - - 6 -
After batteries are installed in all 3 wireless sensors and the main unit is
powered up (with batteries and/or AC adaptor), the main unit will
automatically prompt you to set your unit preference and the initial time
and date. After the atomic clock signal is received, the time and date will
be maintained automatically. If you choose not set any preferences
initially, the main unit will use the defaults and begin searching for the
atomic clock signal to set itself. This may take up to 24 hours and may
not occur at all depending on your geographical location and your
physical surroundings. See “troubleshooting” for atomic clock tips.
SECTION 2 • SETUP
Main Unit Basic Setup
ENGLISH
METRIC
SET UNITS
SET TIME & DATE
EXIT MENU
SET UNITS (ºF/ºC):
1. Press the “OK” button to enter into unit
selection.
2. Press the UP or DOWN button to select
either “ENGLISH” (ºF, mph, inches) or
”METRIC” (ºC, kph, mm). Press “OK” again
to confirm your selection.
ENGLISH
METRIC
SET UNITS
SET TIME & DATE
EXIT MENU
SET TIME & DATE:
1. Press the “OK” button to enter into time
& date setting mode.
2. SET TIMEZONE- Press the UP and
DOWN buttons to select your timezone, or
cycle through all of the timezones and into
GMT (greenwich mean time) world time
zone setting. Press the “OK” button to
confirm your setting and move on.
3. SET DAYLIGHT SAVING TIME (DST)-
“DST” will appear on the lower display. Press the UP and DOWN buttons
to select “ON” or “OFF” for DST. Press the “OK” button to confirm your
setting and move on.
4. SET CLOCK- Press the UP and DOWN buttons to adjust the HOUR
(note the AM and PM indicators) and then press the “OK” button to move
on to setting the MINUTES. Press the UP and DOWN buttons again to
adjust the MINUTES. Press the “OK” button to confirm your setting and
move on.
SET TIME & DATE (CONTINUED):
5. SET THE YEAR- Press the “UP” button to adjust the YEAR. Press the
“OK” button to confirm your setting and move on.
6. SET THE MONTH- Press the UP and DOWN buttons to adjust the
MONTH. Press the “OK” button to confirm your setting and move on.
7. SET DATE- Press the UP and DOWN buttons to adjust the DATE. Press
the “OK” button to confirm your setting and move on.
Your initial time and date setting is complete. You may now exit the
menu and continue with normal weather station operation.
The main unit will start to search for the 3 wireless sensors, and will
also search for the atomic clock signal. When the main unit picks up the
atomic clock signal, the time and date will automatically be maintained
with split second accuracy. See section 6 in the back of this manual for
more information about the atomic clock.
(NORTH)
WIND
MAIN
UNIT
RAIN
TEMP.
& HUMIDITY