AcuRite 01055 AcuLink Weather Station - Manual (Page 3)

T Z O N E - - C S T
4 3
SETUP SETUP
Quick Setup - Display Console
After installing batteries, the Intelli-Time® clock and calendar will
automatically set to the correct time, all you need to do is select your
time zone.
Next, you will need to select your general geographic region for the
Micro-Forecast to function properly. The Micro-Forecast feature
analyzes outdoor temperature, outdoor humidity, pressure changes
and geographic region information to give you the most accurate
forecast a single station forecast can provide.
Adjustable Stand - Display Console
To adjust the display for optimum viewing angle, loosen the locking
knobs and gently tilt the display to the desired angle. Re-tighten the
knobs to set the angle. NOTE: do not set the display angle all the
way forward or backward unless you are wall-mounting the display.
This will cause the display to tip forward or backwards.
Manual Setup - Display Console
Press the SET ( ) button to enter into manual set mode. The currently
selected language will display(”ENGLISH is default)
To adjust the currently selected (flashing) preference item, press and
release the “ ” or “ ” buttons.
To save your adjustments, press and release the “ ” button again to
move on to adjusting the next preference. You will automatically exit
SET MODE if no entries are made for 30 seconds. You may enter
basic setup mode again at any time by pressing and releasing the
“SET” button.
The preference set order is as follows:
LANGUAGE (English, Spanish or French)
TIME ZONE (PST MST CST EST AST HAST AKST)
AUTO DST (Automatically adjust time -/+ on DST calendar dates)
CLOCK HOUR
CLOCK MINUTE
CALENDAR MONTH
CALENDAR DATE
CALENDAR YEAR
UNITS: temperature (ºf or ºc), wind (mph, kph, kn), rain (in. or mm),
pressure (inhg or hpa)
SENSOR TYPE: (large 5in1 or smaller 3in1 )
NOTE: This weather station came with a 5in1 sensor, this display
console was designed to work with either a 5in1 OR a 3in1 sensor- but
not both at the same time. It is recommended that the larger 5in1
sensor be selected for proper operation.
PRESS THE “zone” BUTTON UNTIL YOUR
TIME ZONE IS SELECTED. THE “zone” BUTTON
IS LOCATED IN THE BATTERY COMPARTMENT.
PRESS THE “geo” BUTTON REPEATEDLY
UNTIL YOUR GEOGRAPHIC ZONE IS
SELECTED. THE “geo” BUTTON IS
LOCATED IN THE BATTERY COMPARTMENT
NOTE: IF FRENCH OR SPANISH LANGUAGE IS SELECTED
(SEE MANUAL SETUP TO CHANGE LANGUAGE),
THE TIME ZONE SELECTION ON THE DISPLAY WILL BE G.M.T. -/+ HOURS
A
B C D
E
F G