AcuRite 01055 AcuLink Weather Station - Manual (Page 11)

TROUBLESHOOTING
Set Wireless I.D.
This wireless thermometer
uses long range 433mhz
radio frequency for
communication.
In the event that you have
reception problems due to
interference, both the main
unit and the wireless sensor
have a selectable wireless
ID. The ID switches are
located within the battery
compartments of the
display console and the
integrated wireless sensor.
You may choose A, B or C;
but both the main unit and
the wireless sensor ID's
must match for successful
synchronization.
A B C
Both wireless ID
switches
must match
A B C
20 19
TROUBLESHOOTING
Problem
Bad
Wireless Sensor
Reception
Display Console
Screen Not Working
Possible Solution(s)
no bars
Relocate the main unit and/or the wireless sensor.
Both units must be within 330 feet (100 meters)
from each other. Make sure both units are placed
at least 3 feet (.91 m) from other electronic
appliances and devices that may interfere with the
wireless communication (such as TVʼs, microwaves,
computers etc). NOTE: It may take up to 20 minutes
for the main unit to re-synchronize with the sensor
when batteries are replaced. Use lithium batteries
in sensor when temperature is below -4ºF (-20ºC).
Make sure the A-B-C switch selection in the battery
compartments of the display unit and sensor match.
Batteries may need replacing.
Check that batteries are correctly installed.
Reset the display unit and wireless sensor.
Micro Forecast
displaying “- -”
for highs/lows/
precipitation%
Micro Forecast
Inaccuracies
The Micro Forecast will not display predicted high
or low temperatures or chance of precipitation for
the first few hours after powering on or resetting.
During this initial learning mode, the weather
forecaster will observe changes to learn your
weather patterns and increase the accuracy of the
forecast.
As with any weather forecast, 100% accuracy is
not possible. However, if the micro forecast seems
wildly inaccurate, make certain that your
geographic region is selected properly. The
geographic region selection can drastically affect
the accuracy of the forecast.
NOTICE: The display may fail to start properly due to static
discharge. Press the reset button located on the back of the display
unit to reset the entire unit. Please note that all of the date and time
information will need to be entered manually after a reset.