AcuRite 01055 AcuLink Weather Station - Manual (Page 10)

18 17
CALIBRATION & ADVANCED OPTIONS
Station Pressure Calibration
Once you are in STATION PRESSURE CALIBRATION mode you may
calibrate the value up or down by pressing the “ ” or “ ” buttons.
Note the arrow icons indicate if you are calibrating the value
above(+) or below(-) the uncalibrated raw pressure. Press the “ ”
button to confirm your calibration changes and return to normal
operation- which will then display your calibrated pressure, as well as
useing the calibrated value for the forecast display.
Station Pressure
Station pressure is the second pressure mode. When selected, station
pressure will use the unadjusted pressure value to display in the
“PRESSURE” weather page. It will also use the unadjusted pressure
reading for the forecast feature.
To calibrate
above current
sensor value
“00” will always represent
the raw uncalibrated value
coming in from the sensor
To calibrate
below current
sensor value
CALIBRATED
PRESS PRESS
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove battteries from equipment which is not
to be used for an extended perid of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the
device. Dispose of used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used
batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries
(alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.