AcuRite 01035 Weather Station - Manual (Page 3)

Install 6
“AA”
Alkaline
Batteries
Connect
power
adaptor
Remove
Battery
Compartment
Cover
Installing Batteries - Display Console
The display console will operate under battery power OR AC power
alone, however, it is recommended that batteries be installed to
retain records and to ensure continued operation during a power
outage.
Note that the Weather Ticker will display a scrolling welcome
message and basic instructions after powering on.
IMPORTANT: set the time and date as soon as possible, weather
history data is driven by the time and date and will record incorrect
time and date information if the time and date are not set correctly.
SET “ABC” SWITCH TO MATCH
SENSOR “ABC” SWITCH SELECTION
SETUP
! A B C
Remove Battery
Compartment
Cover
Install 4
“AA” Alkaline*
Batteries
*install lithium batteries for
use in temperatures
below -4ºF
SET “ABC” SWITCH TO MATCH
DISPLAY CONSOLE
“ABC” SWITCH SELECTION
NOTE: Make sure to remove the tape and small plastic rain gauge
stabilizer installed in the bottom of the sensor housing. The rain
gauge will not function until this is removed.
BATTERIES MUST BE INSTALLED FOR THE INTEGRATED SENSOR
TO OPERATE: The integrated sensor features a solar cell for
collecting sunlight and converting it into usable power, this feature is
intended to EXTEND the life of the batteries you install. This sensor
REQUIRES batteries be installed to operate, and will not function on
solar power alone.
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY
SAFE WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND
REGULATIONS.
! A B C
1
2
3 Remove Tape
& Rain Gauge
Stabilizer
-discard-
Installing Batteries - 5-in-1 Multi-Sensor
3 2
WRITE DOWN YOUR
DEVICE I.D. / M.A.C.
You will need the device ID
number that is printed on
the back of the display
for (OPTIONAL) online
connectivity,
so keep it handy!