beautypg.com

Activeforever Spa2Go Portable Spa (Blue) User Manual

Page 8

background image

5. If all above fails to create a short pulse of warm water after stopping flow with finger,
there may be a problem with heater element, pressure switch, high limit switch or
electronic control. The power pack may need to be sent to service center for repairs.
General Notes: Most no heat issues are almost always the result of a dirty filter/low
flow
, a tripped high limit button under pack, or the pump/filter tank was not
properly bled of air, resulting in a rattling pump noise and the pump not flowing

ANY water. Remember if the pump is not flowing a good stream of water the spa

WILL NOT HEAT!!

Some Power Pack units have a high limit
reset button located under the pack about 2
inches inward from right leg.

While power pack is still unplugged!
Push this button. You may or may not feel
a click. Open air bleeder valve counter-
clockwise until water spews out, then close
clock-wise. Plug power pack into outlet,
reset water temperature to 104.

Repeat step #6 to test for warm water

Replace top & cover, let run for 24-48
hours

www.Activeforever.com