beautypg.com

Activeforever Spa2Go Portable Spa (Blue) User Manual

Page 7

background image

1 Turn filter lid retaining lock lid counter clock
wise and remove, remove filter lid, lift out and
remove filter cartridge. Make sure the Gasket
has been replaced securely
2. Place filter lid on tank, thread on filter lid
retaining lock clockwise until snug. Hand tight
only. Do not cross - thread.
3. Remove 3 caps from inside spa suction &
return fittings.
4. Open air bleeder valve counter-clockwise
until water spews out, then close clock-wise.
5. Plug GFCI back into wall outlet, set
temperature to 104 degrees

6. Place index finger over lower
water return inlet hole and stop flow.
Hold for 15 seconds, then pull finger
back approx. 1/2" and see if you feel
a quick short pulse of warm water. If
yes, spa is now heating. This may
have reset a pressure switch, but this
usually indicates a dirty filter/ low
flow condition. If No, go to next step.

This is the Gasket

Open Bleed Valve on top of the filter bucket.
There will a small amount of water to flow out.
To avoid any water to spill onto floor or
surfaces, it is advised to place a towel around
the bleeder valve

Place towel around this section

www.Activeforever.com