Acroprint Time Q +Plus - Manual (Page 13)

13
3.5 Connecting the power cord and securing the access door
Plug in the power cord coming from the wall mount transformer into the
Time Clock terminal. To reattach the access door and secure the unit to
the reversible bracket, screw on the lower front panel of the unit to
tighten the access door.
Power
Cord
Access Door
3.6 Establishing communications between terminal and PC
In most cases the software will automatically locate the PC serial port.
If the software does not locate the serial communications port:
1. From the PC, start the Time and Attendance program.
2. Select the communications icon; then select the correct
communications port and baud rate.
NOTE: The baud rate on the PC must match the baud rate set
on the Time Clock terminal. Default setting on the
terminal is 9600. The baud rate may be changed at the
terminal by using the Supervisor’s badge (see section
12. Manually programming the terminal).
Terminal installation
READ THIS!