Rmc 7155 – Acnodes RMC 7155 User Manual

Page 7

RMC 7155

14” short depth server

All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.

14628 Central Blvd,

Chino, CA91710

tel:909.597.7588, fax:909.597.1939

1-3

Server Chassis Features

The following is a general outline of the main features of the chassis.

System Power

In the RMC 7155, the chassis includes a single 520W power supply.

Serial ATA Subsystem

The chassis was designed to support four SATA hard drives. The SATA drives are hot-swappable units.

Note: The operating system you use must have RAID support to enable the hot-swap capability of the SATA drives (sys-
tem-based RAID is not available for SATA).

Control Panel

The control panel on the provides important system monitoring and control information. LEDs indicate power on, network
activity, hard disk drive activity and system overheat conditions. The control panel also includes a main power button and a
system reset button. The front of the also includes a COM port and two USB serial ports for easy access.

Rear I/O Panel

The 520B's rear I/O panel accommodates one expansion card slot, one COM port (another is internal), two USB ports, PS/2
mouse and keyboard ports, a graphics port and two Gb Ethernet ports.

Cooling System

The chassis has an innovative cooling design that features three 4-cm high-performance system cooling fans. Each of these
fans plug into a chassis fan header on the motherboard. An air shroud channels the airflow generated by the fans to efficiently
cool the processor area of the system.

A fan speed control setting in BIOS allows fan speed to be determined by system temperature [the recommended setting is 3-
pin (Server)].

1.4 Contacting Acnodes

HEADQUARTERS

Address:

Acnodes Corp.
661 Brea Canyon Rd.
Walnut, CA 91789

Tel:

(909) 598-7388

Fax:

(909) 598-0218

Email:

info@acnodes.com

Website: