M-AUDIO EQMan - Manual (Page 11)

11
Included with your EQMan is Windows Remote Control Software. The
Remote Control software is actually two separate applications, an EQ
application and a Volume Control application, which allow you to
configure and control the EQMan card. These applications are used to
change EQ and Volume settings on-the-fly, as well as act together as an
EQ/Volume “program” editor/librarian application.
Windows 3.1/3.11 Driver Installation
If there is no current EQMan Windows MIDI driver installed in your
system simply follow these steps:
1. Start Windows as you usually do.
2. Click open the *Main* group.
3. Click open the *Control Panel.*
4. Click on the *Drivers* icon.
5. Check for a “Midiman EQMan” entry. If one exists, then the driver
has already been installed -- click on “Midiman EQMan” to
highlight it, then click the “Setup” button and proceed to Step 10.
If however the EQMan driver is not present, please continue to the
next step.
6. Click on the "Add" button.
7. Select the "Unlisted or Updated Driver" entry and push the "OK"
button.
8. You will be prompted for a disk drive from which to read the
driver. Insert the EQMan drivers and applications disk into your
floppy disk drive and, if necessary, enter the disk drive specification
in the prompt box. Click on OK.
9. When the "Add Unlisted or Updated Driver" window pops up,
select "Midiman EQMan" and click on OK.
10. The EQMan Driver Setup dialog box will appear (see figure below).
Select the proper Base Address that matches the address jumper
settings of your EQMan.
11. Once the Base Address is selected, verify that the Enable MIDI
Driver checkbox is checked and then click on OK.
12. In order for Windows to install the new driver completely, you will
be required to exit and restart Windows.
13. After restarting Windows, install the supplied Windows Remote
Control software (see Installing Remote Control Software section)
and verify that the Windows drivers are functioning properly.
14. Once you have working Windows drivers, run your favorite MIDI
or audio recording application(s). You will need to configure each
application in order to communicate with the EQMan. Please see
the Configuring Windows Applications to Use the EQMan section
for further information.