HONDA 2013 Civic Hybrid - Manual (Page 302)

Continued 301
uu If a Tire Goes Flat u Temporarily Repairing a Flat Tire
Han
d
lin
g the U
n
expected
10. Unplug the power plug from the accessory
power socket.
11. Unscrew the sealant/air hose from the tire
valve stem. Reinstall the valve cap.
12. Press the pressure relief button until the
gauge returns 0 psi (0 kpa).
13. Apply the repair notification label to the
flat surface of the wheel.
u The wheel surface must be clean to
ensure the label adheres properly.
1. Apply the speed restriction label to the
location as shown.
2. Drive the vehicle for about 10 minutes.
u Do not exceed 50 mph (80 km/h).
3. Stop the vehicle in a safe place.
1 Injecting Sealant and Air
See a Honda dealer for a replacement sealant bottle
and proper disposal of an empty bottle.
Valve Stem
Sealant/Air Hose
Repair Notification Label
■ Distributing the Sealant in the Tire 1 Distributing the Sealant in the Tire
Stop and recheck the air pressure after every 10
minutes of driving as necessary until you reach the
nearest service station where you should have the tire
permanently repaired or replaced.
Speed Restriction Label
13 CIVIC HYBRID-31TR26100.book 301 ページ ２０１２年１２月１８日 火曜日 午後２時５９分
Home
QRG
Index
TOC