HONDA 2012 Fit - Manual (Page 67)

66
uu Indicators u
In
strum
e
nt Pa
nel
Indicator Name On/Blinking Explanation
Transmission
Indicator
*
● Comes on for a few seconds when you
turn the ignition switch to ON
( w , then
goes off.
● Blinks if the transmission system has a
problem.
● Blinks while driving - Avoid sudden starts and
acceleration and have the vehicle checked by a
dealer immediately.
M (sequential shift
mode) Indicator/
Gear Position
Indicator
*
● Comes on when the manual sequential
shift mode is applied.
● Blinks if the transmission system has a
problem.
2 Sequential Shift Mode P. 169
Seat Belt Reminder
Indicator
● Comes on and the beeper sounds if you
are not wearing a seat belt when you
turn the ignition switch to ON
( w . If the
front passenger is not wearing a seat
belt, the indicator comes on about a few
seconds later.
● Blinks while driving if either you or the
front passenger has not fastened a seat
belt. The beeper sounds and the
indicator blinks at regular intervals.
● The beeper stops and the indicator goes off when
you and the front passenger fasten their seat belts.
● Stays on after you or the front passenger has
fastened the seat belt - A detection error may
have occurred in the sensor. Have the vehicle
checked by a dealer.
2 Seat Belt Reminder P. 27
Low Fuel Indicator
● Comes on when the fuel reserve is
running low (approximately 1.64 U.S.
gal./6.2 Liter left).
● Blinks if there is a problem with the fuel
gauge.
● Comes on - Refuel your vehicle as soon as possible.
● Blinks - Have the vehicle checked by a dealer.
* Not available on all models
US FIT-31TK6630.book 66 ページ ２０１１年６月１５日 水曜日 午後４時２３分
2012 Fit
TOC
Home
QRG
Index