HONDA 2012 Fit - Manual (Page 249)

uu If a Tire Goes Flat u Temporarily Repairing a Flat Tire *
248
Han
d
lin
g the U
n
expected
13. Unscrew the sealant/air hose from the tire
valve stem. Reinstall the valve cap.
14. Push the deflate button until the gauge
returns 0 psi.
15. Apply the wheel label to the flat surface of
the wheel.
u The wheel surface must be clean to
ensure the label adheres properly.
1. Apply the speed limit label to the location
as shown.
2. Drive the vehicle for about 5 minutes.
u Do not exceed 50 mph (80 km/h).
3. Stop the vehicle in a safe place.
Air Pressure Gauge
Deflate Button
Wheel Label
■ Distributing the Sealant in the Tire 1 Distributing the Sealant in the Tire
Stop and recheck the air pressure after every 5
minutes of driving as necessary until you reach the
nearest service station where you should have the tire
permanently repaired or replaced.
Speed Limit Label
US FIT-31TK6630.book 248 ページ ２０１１年６月１５日 水曜日 午後４時２３分
2012 Fit
Home
QRG
Index
TOC
* Not available on all models