HONDA 2012 Fit - Manual (Page 246)

245
uu If a Tire Goes Flat u Temporarily Repairing a Flat Tire *
Continued
Han
d
lin
g the U
n
expected
Temporarily Repairing a Flat Tire *
If the tire has a large cut or is otherwise severely damaged, you will need to have the
vehicle towed. If the tire only has a small puncture, from a nail for instance, you can
use the tire repair kit so that you can drive to the nearest service station for a more
permanent repair.
If a tire goes flat while driving, grasp the steering wheel firmly, and brake gradually
to reduce speed. Then stop in a safe place.
1. Park the vehicle on firm, level, and non-slippery ground.
2. Put the shift lever in ( P .
3. Set the parking brake.
4. Turn on the hazard warning lights and turn the ignition switch to LOCK ( 0 .
■ Getting Ready to Temporarily Repair the Flat Tire
1 Temporarily Repairing a Flat Tire *
The kit should not be used in the following situations.
Instead, contact a dealer or a roadside assistant to
have the vehicle towed.
• The tire sealant has expired.
• More than two tires are punctured.
• The puncture is greater than 3/16 inch (4 mm) in
diameter.
• The tire side wall is damaged or the puncture is
outside the tire tread.
• Damage has been caused by driving with the tires
extremely under inflated.
• The tire bead is no longer seated.
• A rim is damaged.
Do not remove a nail or screw that punctured the
tire. If you remove it from the tire, you may not be
able to repair the puncture using the kit.
NOTICE
Do not use a puncture-repairing agent other than the
one provided in the kit that came with your vehicle. If
used, you may permanently damage the tire pressure
sensor.
When the puncture is:
Smaller than 3/16 inch
(4 mm)
Larger than 3/16 inch
(4 mm)
Kit Use
Yes
No
Contact
Area
Instruction
Manual Air Compressor Wheel
Label Sealant Bottle
Expiration Date Speed Limit
Label
* Not available on all models
US FIT-31TK6630.book 245 ページ ２０１１年６月１５日 水曜日 午後４時２３分
2012 Fit
Home
QRG
Index
TOC