FIAT Grande Punto Actual - Manual (Page 134)

132
W
ARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICA
TIONS
INDEX
DASHBOARD AND CONTROLS
SAFETY DEVICES
CORRECT USE OF THE CAR
USING THE MANUAL
GEARBOX
To engage the gears, press the clutch ped-
al fully and shift the gear lever into one of
the required positions (the diagram is
shown on the knob fig. 2-3).
To engage the 6 th gear, move the gearshift
lever pressing slightly rightwards to pre-
vent engaging the 4
th gear accidentally. Do
the same for shifting from 6 th to 5 th gear.
IMPORTANT The car can only be put in-
to reverse gear when it has stopped mov-
ing completely. With the engine running,
before engaging the reverse, wait at least
2 seconds with the clutch pedal fully down
to prevent damage and grating of the
gears.
fig. 2 F0M0142m
To change gears properly
you must push the clutch
pedal fully down. It is therefore es-
sential that there is nothing under the
pedals: make sure the mats are lying
flat and do not get in the way of the
pedals.
WARNING
Do not drive with your hand
resting on the gear lever as
the force exerted, even if
slight, could lead over time to
premature wear on the gearbox inter-
nal components.
To engage reverse R (6-speed gearbox)
from neutral, proceed as follows: raise ring
A under the knob and at the same time
move the gearshift lever leftwards and
then forward fig. 2.
For 1.4 16v version, to engage reverse R
from neutral, lift the sliding ring A under
the knob and shift the lever to the right
and back fig. 3.
To engage reverse R (5-speed gearbox)
from neutral, proceed as follows: raise ring
A under the knob and at the same time
move the gearshift lever rightwards and
then forward fig. 2.
fig. 3 - 1.4 16v version F0M0285m