FIAT Panda - Manual (Page 70)

CLOSING
Proceed as follows:
❒ keep the bonnet raised with one hand and remove
rod C fig. 59 from housing E with the other,
inverting the opening motion, then fit it back into
its catch D;
❒ lower the bonnet to approximately 20 centimetres
from the engine compartment and let it drop.
Make sure that the bonnet is completely closed
and not only fastened by the safety catch by trying
to open it. If it is not perfectly closed, do not try
to press the bonnet lid down but open it and
repeat the procedure.
IMPORTANT Always check that the bonnet is closed
correctly to avoid it opening while the car is
travelling.
WARNING
Perform these operations only when the
car is stationary.
The following plate fig. 60 is applied inside the engine
compartment:
ROOF RACK/SKI RACK
The attachments B fig. 61 are located in the areas
illustrated in the figure and can only be accessed with
the doors open and after removing the flaps A fig.
61 from the roof. The Lineaccessori Fiat includes
a dedicated roof rack/ski rack for this car. Follow the
instructions contained in the assembly kit to fit the
roof rack/ski rack.
Vehicle with longitudinal roof rack bars
The areas for the attachments are highlighted by
reference holes B fig. 61. Holes B are located on the
longitudinal roof rack bars, on the side towards
the vehicle centre line. Do not fit the roof rack in
positions different from those indicated by holes B.
The Lineaccessori Fiat includes a dedicated roof
rack/ski rack for this car with longitudinal roof rack
bars. Follow the instructions contained in the
assembly kit to fit the roof rack/ski rack.
Vehicle with sun roof
There is not roof rack for vehicles with sun roof.
WARNING
After travelling for a short distance,
check that the fixing screws for the
attachments are correctly tightened.
fig. 60 F0W1004
66
GETTING TO
KNOW YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX