FIAT Panda - Manual (Page 233)

RADIO (TUNER)
INTRODUCTION
When the radio is switched on, the last function
selected before it was switched off is activated:
Radio, CD, CD MP3 or Media Player (only with
Blue&Me™) or AUX (only with Blue&Me™, for
versions/markets, where provided).
To select the Radio function when another audio
source is being listened to, briefly press the FM AS or
AM buttons depending on the desired band.
Once the Radio mode has been activated, the display
will show the name (RDS stations only) and the
frequency of the selected radio station, the frequency
band selected (e.g. FM1) and the preselect button
number (e.g. P1).
FREQUENCY BAND SELECTION
With the Radio mode active, press the FM AS or AM
button briefly and repeatedly to select the desired
reception band.
Each time the button is pressed the following bands
are selected cyclically:
❒ By pressing the FM AS button: “FM1”, “FM2” or
“FMA”;
❒ By pressing the AM button: “MW1, MW2”.
Each band is highlighted by the name in the display.
The last station selected on the respective frequency
band will be tuned into.
The FM band is divided into sections: FM1, FM2 or
"FMA"; the FMA reception band is reserved for
broadcasters stored automatically using the
Autostore function.
PRESET BUTTONS
The buttons numbered from 1 to 6 are used to set
the following preset stations:
❒ 18 in the FM band (6 in FM1, 6 in FM2, 6 in FMT or
"FMA" (on some versions);
❒ 12 in the MW band (6 in MW1, 6 in MW2).
To listen to a preset station, select the desired
frequency band and then briefly press the
corresponding preset button (from 1 to 6).
By pressing the preset button for more than 2
seconds, the tuned station will be stored. The storing
phase is confirmed by an acoustic signal.
229
SOUND-S
YSTEM