FIAT Grande Punto Actual User Manual

Page 184

183

SAFETY

TING

AND DRIVING

ARNING

LIGHTS AND MESSAGES

IN AN

EMERGENCY

TECHNICAL

SPECIFICA

TIONS

INDEX

CONTROLS AND DEVICES

SER

VICE

AND CARE

Replacing the windscreen
wiper blades fig. 9

How to remove the blade:
❒ raise the windscreen wiper arm A;
❒ rotate blade B 90° around pin C, lo-

cated at the end of the wiper arm;

❒ remove the blade from the pin C.
How to insert the blade:
❒ fit pin C into the hole located in the

middle of the blade B;

❒ lower the arm so the blade rests back

on the windscreen.

fig. 9

F0M0161m

Changing the rear
window wiper blade fig. 10

Proceed as follows:
❒ raise the cover A and remove the arm

from the car by slackening the nut B
that fastens it to the pivot pin;

❒ fit the new arm, positioning it correct-

ly, and fully tighten the nut;

❒ lower the cover.

fig. 10

F0M0162m

SPRAY NOZZLES

Windscreen washer fig. 11

If the jet is not coming out, firstly check
that there is fluid in the reservoir (see
“Checking levels” in this section).

Then check that the nozzle holes are not
clogged; use a needle to unblock them if
necessary.

fig. 11

F0M0163m

167-186 ACTUAL 2ed EN 30-04-2010 12:40 Pagina 183