FIAT 500 - Manual (Page 171)

❒ fit the new arm, positioning it correctly, and fully
tighten the nut;
❒ lower the cover.
WINDSCREEN JETS (WASHERS)
If the jet of fluid is inadequate, firstly check that
there is fluid in the reservoir (see "Checking fluid
levels" in this chapter).
Then check that the nozzle holes are not clogged;
use a needle to unblock them if necessary.
The windscreen jets are directed by adjusting the
angle of the nozzles.
The jets should be directed at about 1/3 of the
height from the top edge of the windscreen fig. 141.
IMPORTANT In versions with a sun roof, make
sure that the sun roof is closed before operating the
front jets.
REAR WINDOW JETS (WASHERS)
Rear window washer jets are fixed.
The nozzle holder is on the rear window fig. 142.
fig. 140 F0S0109
fig. 141 F0S0110
fig. 142 F0S0111
170
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX