RIDGID MONSTER BOX - Manual (Page 7)

Extension Cord-
• Follow all Extension Cord manufacturer’s Warnings and Instructions.
• After removing knock-out, insert rubber hole protector. Do Not insert extension cord through hole without protector
in place.
• Only use a three-wire extension cord with all three prongs intact. Never remove the round grounding prong.
• Extension cord must be connected to a 120 Volt or 230 Volt GFCI protected outlet with proper ground. If GFCI outlet
is not available, use an extension cord with GFCI protection built in.
• Check the insulation and plugs of extension cord before using. Do Not use cord if it is worn or damaged.
• Do Not overload extension cord.
• Remove extension cord from the hole before moving or transporting storage chest.
• An extension cord not marked for Outdoor Use must only be used Indoors.
• Do Not connect extension cord to outlet that also supplies critical safety equipment with power.
Cordless Power Tool Battery Chargers-
• See Charger’s Owner’s Manual for proper use and care of charger and batteries. Follow all Warnings and
Instructions provided with your battery charger.
• Place chargers and electrical connections in tray.
• Chargers are Dry location use only. Do Not expose to liquid, vapor, or rain. Should your charger become wet, Do
Not attempt to use. Unplug extension cord from supply before handling wet charger or cords.
• Only use chargers and batteries that are intact and operating properly.
• Do Not touch metal prongs when plugging charger into extension cord.
• Keep flammable materials like paper or rags away from charger, cords or connections.
• Do Not place or attempt to charge lead acid, car type batteries in storage chest.
POWER PASS™ electrical pass through (included):
The Job Site models listed in the previous section have a pre-determined
mounting area suggested for use with the POWER PASS electrical
pass through or the Accessory Resident Power Supply Box (purchased
separately).
Knockout removal :
1. Choose the desired location and secure a hammer or mallet.
2. Using a mallet, strike the knockout feature until it breaks free of the
sheet metal wall. Twist the plug from wall with pliers, if necessary.
3. Ensure all sharp edges are removed. Insert the included grommet to
ensure power cords are protected from raw sheet metal edges.
RECHARGING POWER TOOLS IN YOUR MONSTER BOX™
WARNING
5