Edimax Technology PS-1210MFn - Manual (Page 18)

13
9. Please set the network settings for the MFP Server manually.
By default, the network settings are as follows.
IP Address: 192.168.2.2
Subnet Mask: 255.255.255.0
If you have selected “DHCP”, the MFP Server will try to
determine your network settings automatically. If a DHCP
Server is present within the network, the MFP Server will
automatically obtain and configure the network settings
assigned by the DHCP Server. The assigned IP Address will be
shown in the IP Address fields. If no DHCP Server is present
within the network, please assign the network settings of the
MFP Server manually. Please click “Next” once you have found
appropriate network settings for the MFP Server.
Note:
The MFP Server IP Address should be in the same network
segment with the connected computer. If the network settings are
incorrect, a message will be prompted to remind you after you click
“Next”. Please make sure that you have set the right settings
before going to the next step. If you don’t want to set it now, please
click “Cancel” to finish the installation. You can then use the
“Server Manager” utility to configure the MFP Server.