Edimax Technology PS-1210MFn - Manual (Page 10)

5
4. MFP Server Installation in Windows
2000/XP/Vista/7
Before you start, you should have:
„ One computer with Windows 2000 SP4 above, Windows XP
SP1 above or Windows Vista (32-bit/64-bit) / Windows 7.
„ One MFP or printer with USB port and an installation CD
„ One Category 5 Ethernet Cable
„ One USB Cable
4.1 Hardware Installation Procedure
1. Unpack the MFP Server package and verify that all the items
listed in the previous section are provided.
2. Plug the USB cable to the MFP Server with the MFP or printer
that you want to share on the network.
3. Connect the MFP Server to your network by attached the
network cable to the network port of the MFP server.
4. Connect the power adapter to the MFP Server. The MFP Server
will perform the Power-On-Self-Test (POST) after it is powered
on. When the Status LED is unlighted, the MFP Server is ready.
Note:
1. You must use the power adapter shipped along with the
MFP Server, do NOT use any other power adapter from
other sources.
2. To prevent the compatibility problem between MFP Server
and a few MFP or printer, it is recommended that you power
on the MFP Server before the MFP or printer.