3Com 09-1457-000 User Manual
Page 29
AutoLink for Windows 3.x, Windows for Workgroups, and DOS
19
AutoLink for Windows 3.x, Windows for Workgroups,
and DOS
If no other PC Cards are installed, you can use 3Com’s
AutoLink
™
software program to automatically install the
NetWare ODI client software (including the driver), and to
modify the CONFIG.SYS and AUTOEXEC.BAT files.
To use the AutoLink program, the PC must meet these
requirements:
■
Use Novell NetWare 3.12, 4.10, or 4.11 network
operating system
■
Have only one LAN PC Card installed
■
NetWare DOS ODI client
1 Make sure the LAN PC Card is installed and connected
to the network, as described in Chapter 1.
2 Boot the PC under DOS.
3 Insert LAN Installation Disk 2 into the floppy drive
and type
a:install
[Enter]
at the DOS prompt
4 Choose Auto Install and Config for NetWare (AutoLink).
An information box appears.