3Com 09-1457-000 - Manual (Page 23)

Windows NT 13
Windows NT 4.0 Installation without Networking Installed
If you have networking installed, go to the next section to
install the driver.
1 In the Control Panel, double-click Network.
The system prompts:”Windows NT Networking is not
installed. Do you want to install it now?”
2 Click Yes.
This opens the Windows NT network Setup Wizard.
3 Check Wired to the network and click Next.
Windows prompts “To have setup start searching for a
network adapter”.
4 Click Select from List.
5 Click Have Disk.
6 Insert LAN Installation Disk 1 into the floppy drive
and click OK.
7 When the Select OEM Option window opens, select
3Com Megahertz LAN PC Card (Ethernet) and click OK.
The Network Adapters list shows the 3Com Megahertz
LAN PC Card with a check mark on it.
8 Click Next to continue.
9 In the Network Protocols list, place a check mark next
to each network protocol that Windows NT will use
and click Next.
Most Microsoft NT networks use the NWLink IPX/SPX
Compatible Transport. If you are not sure, ask your system
administrator or MIS department.
10 In the Network Services window, place a check mark
in the box next to each desired service.
11 Click Next to continue.
12 Click Next to install the selected components.