3Com 09-1457-000 - Manual (Page 26)

16 C HAPTER 2: I NSTALLING THE N ETWORK D RIVER
Windows NT Version 3.51
1 Make sure the PC Card is installed and connected to
the network as described in Chapter 1.
2 In the Main group double-click Control Panel.
3 On the Control panel, double-click the Network icon
and click the Add Adapter tab.
a If Windows NT networking is not installed, click Yes to
install Windows NT networking.
The Windows NT Setup window appears.
b Enter the directory name where the Windows NT
installation files are located.
c Click Do Not Detect.
Windows NT does not fully support Plug and Play and
cannot detect the LAN PC Card.
d Click Continue.
The Add Network Adapter window appears.
4 Select Other Requires disk from manufacturer from
the list.
5 Click Continue.
6 Insert LAN Installation Disk 1 into the floppy drive.
Enter the name of the drive (for example, A:\) and
click OK.
7 Select 3Com Megahertz LAN PC Card from the list and
click OK.
The LAN PC Card files are copied to your PC.
8 Click OK to accept the default settings for the LAN PC
Card or enter new settings.
9 If networking is already installed, enter the IP Address if
prompted, and reboot the PC to activate the network.
10 If networking is not installed, select the transport
protocol (NWLink IPX/SPX compatible transport,
TCP/IP protocol, NetBEUI protocol) in the Windows NT
Setup Window.
a Click OK.
b If prompted, enter the directory name where the NT
installation files are located.