Xantrex Technology XFR 2800 - Manual (Page 33)

Features and Specifications
Specifications
Release 2.1 31
Additional
Features
Remote
Programming
and
Monitoring
Switching Frequency nominal 31 kHz (62 kHz output ripple).
Output Hold-up Time Greater than 10 ms with interruption of AC line,
for nominal AC input and full load.
Maximum Voltage Differential from
either output to safety ground ±600 Vdc
Insulation Resistance Input to chassis: >30 M Ω, with 500 Vdc;
Output to chassis: >20 M Ω, with 1000 Vdc.
Isolation Voltage Input to output: 1350 Vac
Remote Start/Stop and Interlock 2.5-15 V signal or TTL-compatible input,
selectable logic. TTL input impedance: 2 k (in
series with one diode drop).
Remote Analog Programming (Full
Scale Input) Voltage and current programming inputs
(source must be isolated): 0-5 k, 0-10 k
resistances; 0-5 V, 0-10 V (default) voltage
sources. Input impedance (V and I):
approximately 100 k.
Remote Monitoring Output voltage and current: 0-5 V, 0-10 V
(default);
Output impedance (V and I): approximately
221
Ω.
Output short circuit current: approximately
50 mA.
Remote Programming and
Monitoring Accuracy 1% zero to full scale output for the default
range.
Maximum Remote Sense Line Drop
Compensation 5 V/line (Line drop is subtracted from total voltage
available at supply output.)
Optional Isolated Program and
Readback (V&I) 0-5 V (ISOL interface); input impedance: 200 k;
output impedance: 221
Ω.
Optional Digital Control RS-232, GPIB interfaces