Yamaha HTR-6180 - Manual (Page 31)

27
En
Connections
PRE
P
ARA
T
ION
English
Both FM and AM indoor antennas are supplied with this
unit. Connect each antenna correctly to the designated
terminals. In general, these antennas should provide
sufficient signal strength.
• The AM loop antenna should be placed away from this unit.
• A properly installed outdoor antenna provides clearer reception
than an indoor one. If you experience poor reception quality,
install an outdoor antenna. Consult the nearest authorized
Yamaha dealer or service center about outdoor antennas.
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
Connecting the wire of the AM loop antenna
y
The wire of the AM loop antenna does not have any polarity
and you can connect either end of the wire to AM or GND
terminal.
Assembling the supplied AM loop antenna
Connecting the FM and AM
antennas
Notes
DIGITAL INPUT XM
ANTENNA
REMOTE
SIRIUS
DIGITAL
OUTPUT
TRIGGER
OUT
CD DTV/CBL
OPTICAL COAX
DVD
AM GND
HD Radio
FRONT B/ZONE B/
ZONE 2/PRESENCE
MD/CD-R MD/CD-R
FM
75 Ω UNBAL.
R R L
5 4 3 2 1
EXTRA SP
Indoor FM
antenna
(supplied)
Ground (GND terminal)
For maximum safety and minimum interference, connect the
antenna GND terminal to a good earth ground. A good earth
ground is a metal stake driven into moist earth.
AM loop antenna
(supplied)
Outdoor AM antenna
Use a 5 to 10 m (16 to 33
ft) vinyl-covered wire
extended outdoors from a
window.
(U.S.A. model)
Press and hold Insert Release
(U.S.A. model)
Open the lever Insert Close the lever
(Canada model)
(U.S.A. model)
(Canada model)